![]() ![]() Edit database properties using Section Browser.(Be sure to use pro in the name of the file.) Rename the file, to, for example, Twpro.xml.SadefPro.xml) from C:\ProgramData\Autodesk\Structural\Common Data\20xx\Data\Prof folder to C:\Users\username\AppData\Roaming\Autodesk\Structural\Common Data\20xx\. Find a similar section in one of existing thin-walled section databases (e.g.These are some points to be checked while doing analyses structure in STAAD pro software. Sometimes, the design set default the interaction ratio limit to 0.90 instead 1.0 If it exceeds STAAD will show fail even if it is less than compression - 180.(Member specification) Check deign result (Output- Member passes, failed to be checked.Cutoff mode shape, Base shear has to be checked. In case of seismic load, sum of mass should be more than 90 percent.Understand Deflection patter by View the animation for any excessive deflection of nodes.axial load, M and V in any member in the structures and see whether it is acceptable or not) Check Maximum deflection (Summary of Displacement).After Run file for Analysis and Design following thing need to take care. Understanding for assigning LY and LZ in STAAD Proĭesign Parameter of Steel Structure in STAAD ProĪll above check list need to check during modelling and Analysis. Please read following blog for Design parameter: Add envelop specially for Strength and Serviceability check.Add Load Combinations for Strength and Serviceability.Check for Seismic load (need to add as first basic load and after seismic load write “CHANGE” in command file.Apply load dead load for other structural/ nonstructural member i.e Wall load, Floor Load, Stair case, Grating Load etc.Check for Seismic Definition and Parameter.Check for Wind Definition and parameter. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |